Traxxas TMAXX t-maxx 2.5 electric conversion (black) motor mount 540 550 motor

Description: Traxxas Tmaxx 2.5 electric motor mount. Fits 540 and 550 size brushed or brushless motors. Mounts to existing chassis screw holes, you will need to remove the fuel tank and battery/switch box. Motor screw holes are 25mm apart. 3D printed with black Premium PLA+ thermoplastic. Motor not included, you will receive the mount and the mounting screws. Your item will be shipped via USPS Ground Advantage with tracking included.Ground Advantage has replaced First Class Package Service®***please see my other listings for the 3.3 TMAXX complete mount set, 2.5 TMAXX mount set, and all individually sold items available. ***New aluminum motor mount with plastic adapter plate is now available for Tmaxx 2.5 and 3.3 type chassis. Thank you!!! Recommended basic setup: 2.5 TMAXX with a two speed transmission and reverse (Black Transmission) 540-550 brushed motor or 3650-3660 brushless motor. 19T 32P pinion gear and 72T 32P spur gear. ESC capable of forward only. 3s 5000mah or similar battery pack. A channel splitter (servo Y harness) to run the brake servo and ESC together on the receiver’s throttle channel. If the brake engages while going forward you will need to reverse the motors polarity and reverse the throttle channel on your transmitter. Transmission adjustments, adjust gear settings so that the forward and reverse gears engage at low RPMs. Tune the shift point of the second speed to happen sooner. - Turn the adjustment screw 1/8 turn counterclockwise to lower the shift point (earlier shifts) - Use 1/8 turn increments to find the approximate, desired shift point. Note: Some Basic Tips When you attach the mount to the chassis use the included screws they should go upwards through the chassis screw holes then thread up into the mount from underneath the chassis. See the mounting screw location photo for reference. Please be aware that some aftermarket chassis are different than the original Traxxas 2.5 Tmaxx chassis and might be missing some of the screw holes needed. Avoid using any type of countersunk or small head motor screws to attach your motor to the mount. Add flat washers to your motor screws or use the included large head motor screws, it will clamp more of the mount surface preventing the motor from moving around and possibly damaging the mount or stripping your gears. Motors with higher RPMs are better at reaching second speed sooner. Your motor operating temperature range should be around 120°F to 150°F max. If you start to see 150°F or more, it's time to change your pinion/spur gear ratio or check your drive train for binding. It is also a good idea to add a motor heat-sink or cooling fan to your motor.

Price: 10.5 USD

Location: USA

End Time: 2024-03-17T21:25:24.000Z

Shipping Cost: 0 USD