Patented 6.5L Pneumatic/Manual Oil Extractor for Oil Change Pump for Automotive

Description: Patented 6.5L Pneumatic/Manual Oil Extractor for Oil Change Pump for Automotive Fluids Vacuum Evacuation Product Description【Humanized Design】With EWK oil extractor for oil change pump, the engine oil or transmission fluid can be easily and cleanly extracted directly through the dipstick tube, and the sealing cap is attached to prevent the liquid from spillage during transport.【Dual-Purpose】Equipped with pneumatic and manual mode depend on the environment and your own equipment. The manual mode requires no other equipment to use, while the pneumatic mode turns the pump into a high-speed oil changer. (Suction speed: 1.8L/min.)【No Oil Left】The vacuum oil changer comes with 2 sizes of upgraded extra-long tubes with different diameter. Slide it as far as possible to reach the very bottom of your reservoir and suck up every drop of oil.The replacement hose (SKU: EB0278) and 3.5 x 4.5 mm super slim hose (SKU: EB0277) are available.【Wide Application】Perfectly extracts most fluid types: engine oil, transmission fluid, coolant, and power steering fluid. Applicable for cars, motorcycles, lawnmowers, boats, jet skis, etc. *Not compatible with Mercedes W212 E350, and C218 CLS 350. *Note: Gasoline and fluids with high volatility, high corrosion, high alkalinity, and high temperature are FORBIDDEN to be used on the extractor.InstructionRemove the oil dipstick and insert the extension tube into the dipstick pipe until it reaches the bottom of the oil pan. Connect the main tube with the extension tube in place.Choose your mode: For pneumatic mode, connect to an air compressor. For manual mode, pump the handle for 10 seconds (1 s/pump) to initiate auto extraction. After 30s, might need to pump again to maintain the vacuum and ensure the oil is fully drained.After extracting all the oil, press the decompression valve to release the unit's built-up pressure for 5 seconds.Remove the main tube, collect the used fluid in a separate container, and transport it to a nearby recycling center for proper disposal.Safety PrecautionDo not use for extracting or storing gasoline or other flammable liquids.To make the extraction job smooth and easy, evacuate the oil while it is warm. Working temperature between 35°F-140°F (2-60 °C).Do not exceed or below its recommended working pressure—a suitable working pressure range of 40 to 170 psi (2.8 to 12 bar).Before extraction, make sure the tubes are connected tightly.In order to maintain the vacuum pressure in manual mode, after 30s, might need to pump again to ensure the oil is fully drained.In order to maintain the consistent vacuum pressure, please close the air inlet valve while operating in manual mode.DO NOT extract oil over the Limited Line on the oil extractor to prevent overflow. If the fluid goes over the Limited Line, it might flow into the vacuum chamber and cause leaking. The fluid should not exceed the limit line either while pouring.After use, please drain the liquid, clean it thoroughly, and store it in a cool, dry place.

Price: 69.99 USD

Location: Fennville, Michigan

End Time: 2024-12-01T04:26:38.000Z

Shipping Cost: 0 USD