Palomar Engineers Flex Radio 6500/6600/6700 Transceiver RFI Kit, RFI Range 1-60

Description: Palomar Engineers Flex Radio 6500/6600/6700 Transceiver RFI Kit, RFI Range 1-60 Mz, 12 Filters Flex Radio 6500/6700 series RFI kit is designed to be installed on your radio transceiver to reduce Radio Frequency Interference (RFI) caused by common mode current on the coax output (2) of your radio, the AC/DC power cable, mic input, USB transverter RX/TX, speaker, ethernet I/O, and flex wire I/O, and ALC/PTT. This kit will help reduce or eliminate:1. “Hot mic” RFI caused by poor grounding of antennas or common mode currents from linear amps feeding unbalanced (coax fed) antennas without baluns/line isolators.2. RFI to neighbor’s electronic devices including audio/video systems, computers, telephones, garage door openers, etc.3. RFI to your other radios, audio/video systems, computers, telephones, etc.A side benefit is a reduction in noise floor in your receiver depending on the amount of noise being introduced by common mode currents (which are blocked/reduced by the chokes in this kit). These chokes use a special mix of ferrite core material that is effective in suppressing radio frequency interference from transmitters and high noise floor on receivers. The split beads beads are easy to use, don’t require modification of the protected equipment and work in almost all cases, even when plug-in filters fail.Use of the chokes often helps cure SWR problems between transceiver and a linear amp and between transceiver and antenna tuner or direct to antenna. The DC power line choke helps keep common mode current out of the power line which could cause interference to other devices connected to the same power line if not suppressed.This kit includes 5 ring filters (ID=1.4") and 7 1/2" ID split beads and installation instructions.For additional RFI suppression, use a feed line choke at the antenna feed point to suppress common current on the coax feed line and a coax noise filter at the radio end of the coax to reduce common mode noise.If you use a linear amplifier use an amplifier RFI kit for additional RFI interference suppression. Palomar Engineers Flex Radio 6500/6600/6700 Transceiver RFI Kit, RFI Range 1-60 Mz, 12 Filters Flex Radio 6500/6700 series RFI kit is designed to be installed on your radio transceiver to reduce Radio Frequency Interference (RFI) causéd by common mode current on the coax output (2) of your radio, the AC/DC power cable, mic input, USB transverter RX/TX, speaker, ethernet I/O, and flex wire I/O, and ALC/PTT. This kit will help reduce or eliminate: 1. “Hot mic” RFI causéd by poor grounding of antennas or common mode currents from linear amps feeding unbalanced (coax fed) antennas without baluns/line isolators. 2. RFI to neighbor’s electronic devices including audio/video systems, computers, telephones, garage door openers, etc. 3. RFI to your other radios, audio/video systems, computers, telephones, etc. A side benefit is a reduction in noise floor in your receiver depending on the amount of noise being introduced by common mode currents (which are blocked/reduced by the chokes in this kit). These chokes use a special mix of ferrite core material that is effective in suppressing radio frequency interference from transmitters and high noise floor on receivers. The split beads beads are easy to use, don’t require modification of the protected equipment and work in almost all cases, even when plug-in filters fail. Use of the chokes often helps cure SWR problems between transceiver and a linear amp and between transceiver and antenna tuner or direct to antenna. The DC power line choke helps keep common mode current out of the power line which could cause interference to other devices connected to the same power line if not suppressed. This kit includes 5 ring filters (ID=1.4") and 7 1/2" ID split beads and installation instructions. For additional RFI suppression, use a feed line choke at the antenna feed point to suppress common current on the coax feed line and a coax noise filter at the radio end of the coax to reduce common mode noise. If you use a linear amplifier use an amplifier RFI kit for additional RFI interference suppression. × Buy now and save! Tell a friend Visit store Watch now Postage info Click the Postage tab above the listing description for more info Click the Postage tab above the listing description for more info! Additional delivery notes PICK UP OPTION Sorry, our items are NOT available for pick-up. PAYING VIA PAYPAL We accept PayPal on our all our items so you can shop with confidence. Simple choose the PayPal option when proceeding through the checkout. Additional Information No additional information at this time Ask seller a question You might also like Palomar Engineers HF Linear Amplifier RFI Kit - Generic DC Powered - 5 Filters f Palomar Engineers HF Linear Amplifier RFI Kit - Generic (all brands) AC Powered Contact To contact our Customer Service Team, simply click the button here and our Customer Service team will be happy to assist. Ask seller a question © PALOMAR-ENGINEERS.COM Postage Click the Postage tab above the listing description for more info Payment Accepted Payment Methods PayPal Returns Returns are not accepted Buyer will pay for return shipping. Additional Information: All returns will be exchanged for like product or store credit provided they are returned within 30 days with original packaging and all manufactured products are in original shipped condition with unsealed product labels. All cash refunds subject to 15% restocking fee. eBay integration by

Price: 84.95 USD

Location: Oceanside, California

End Time: 2023-12-21T13:04:25.000Z

Shipping Cost: N/A USD