NEW FISH Koi Pond Vacuum II - Koi Pond Muck Buster 4.5 Gallon 2 HP 2yr Warranty

Description: Matala Pond Vacuum II The new energy efficient 2 H.P. motor is made with high quality German made components. In suction tests, Matala Pond Vac II is four times more powerful than its competition with a suction lift 5’ above water.Also known as the “Muck Buster”, the vacuum easily removes algae, sludge, dead plants, leaves and even small pebbles up to 3/8” in diameter.The auto fill and drain cycles allow for water to fill the vacuum canister, then simply discharge water into garden beds. The on/off cycle is approximately 40 seconds vacuum and 20 seconds drain out. During the vacuum cycle the holding tank fills with dirty water. Once it is full the motor will turn off automatically. The dirty water will start to drain out the drain hose to the garden or yard drains. When it is empty, it turns itself back on automatically and continues to vacuum. Use the optional mesh bag to capture coarse debris before releasing the dirty water to the garden or yard drain. The dirty pond water is great for your garden plants! Do not return dirty water back to the pond. In this way you can use the vac to make monthly water changes. Safe for use in fish ponds and water gardens.The Muck Buster Vacuum II is perfect for hobbyist ponds up to 3000 gallons. The holding tank is approximately 4.5 gallon capacity. The 5 extension tubes are approximately 15 inches long each and can reach depths up to 6 feet. The suction hose is 16 feet long and the drain out hose is 8 feet long.Useful Tips:- Open yellow ring on handle for extended suction time. Close with finger for increased suction power.- Place Vacuum tank up high so that drain out hose with flapper valve is lower than bottom of tank.- Use smallest vac head possible for the job in order to prolong suction time.- Periodically check the flapper valve on end of drain hose for obstructions and good movement.-2 Year Limited Warranty.PrevNext Collection container with motor casing and 5 m (16 ft) cable. 2.5 m (8 ft). discharge hose with integrated blocking flap. 5 m (16 ft).suction hose, hose and piece, 5 extension tubes. 3 adjustable floor nozzles (for particle size 2, 5, 10 mm). (for particle size 1/10”,.1/5”,3/8”) Sludge collection bag. Operation instructions. The vacuum feet (Please see picture 9,10).Safety instructions Power connection Only operate the device when no people are in the water! Before reaching into the water always unplug all devices located in the water. Only operate the device from an outlet that has been installed in accordance with directions. Compare supply voltage (V) and supply frequency (Hz) of your power source with the data on thenameplate. These data must agree. Ensure that the device is protected via a residual current protective circuit with a rated residual current ofmaximum 30Ma. Please consult an electrician! For safety plug the vacuum into an electrical outlet with a (GFCI) Ground Fault Circuit Interrupter. Electrical installations for garden ponds must satisfy the international and national building determinations. Do not carry or pull the device by the connecting cable! Keep the power plug and all connection points dry! The device may not be operated if cable or casing is defective! Please consult your dealer or a specializedworkshop.Assembly1. Loosen the container clamps and remove motor casing. Take all parts out of the collection container.2. Replace the motor casing and lock the clamps.3. Insert the suction hose end into the upper opening of the collection container and lock by turning lightly tothe right. (Please see picture 2 )4. Attach the extension tubes (number as required) and fit a suitable suction nozzle. (Please see picture 5,6)5. Insert the open end of the discharge hose (the end of the hose without one way flapper Please see picture3) into the lower discharge opening of the collection container. (Please see picture 4 ) The hose end withone way flapper should be away from the vacuum at farthest point. (Please see picture 7 )Setup1. Set up the vacuum near the pond. The minimum clearance to the edge of the pond is 2 m (6.5 ft) for safetyreasons. The device should be set up as close to water level as possible. Make sure the device isstanding firmly.2. Lay the discharge hose in such a manner that the sludge water is conducted into shrubbery or grassy areaduring draining. Lay the discharge hose flat on the ground (if possible with a slight incline downward).3. Fasten the sludge collection bag on the end of the discharge hose as needed (for example whensuctioning hair algae) (Please see picture 8), so that the cleaned water, if necessary, can be returned tothe pond.4. Connect the device to the mains power.2Operation1. Insert one of the supplied nozzles (for particle size 2, 5, 10 mm). (for particle size 1/10”,.1/5”,3/8”)2. Turn on the device using the main switch at the motor casing.3. Vacuum up the sludge with slow and even movements. Keep the vacuum hose below waist level for bestperformance. When the collection container has reached its maximum liquid level, the vacuum will shut offautomatically for 25 seconds.The one way flapper at the end of the discharge hose (Please see picture 2338) will open and the sludgeruns out of the collection container. After 25 seconds the vacuum will turn on automatically again and thecleaning of the pond can be continued.4. After use turn off the vacuum at the main switch.Maintenance and repairPlease observe the safety instructions.For the most part, the vacuum is maintenance-free. After use, merely rinse out the collection container and thesludge collection bag and clean the foam filter.1. Switch off the Vacuum Cleaner using the main switch and unplug the power plug.2. Remove all hoses and the motor casing.3. Rinse the collection container with the garden hose until there is no more residue in it.4. Pull the foam filter off and wash it out with garden hose water. The same applies for the sludge collectionbag.Attention! Never use the vacuum without the foam filter!5. Always check the float for ease of movement.Operating instructionsThis device has been developed with special consideration of technical safety standards.Nevertheless, the following instructions must be complied with to use the device safely: The minimum clearance to the edge of the pond is 2 m / 6.5 ft. for safety reasons. The device may only be used for suctioning deposits on the pond floor. The device may only beimplemented for private use-. Never vacuum up flammable or toxic liquids like gasoline, copy machine toner or other volatile substances. Never vacuum up acids. Never use in the presence of explosive liquids or fumes. The device is not explosion protected. Never vacuum up asbestos or asbestos dust. Never vacuum up hot or smouldering ashes, smouldering cigarette butts or similar objects. Never vacuum up dirt, such as dust, sand or similar things. Never make technical changes to the device. Only use original replacement parts and accessories made for the Matala Pond Vacuum II. Only have the device repaired at authorized customer service locations. Do not operate the device in the rain or leave it standing in the rain.

Price: 265 USD

Location: McKinney, Texas

End Time: 2024-08-16T16:33:37.000Z

Shipping Cost: 0 USD