New DISH 20.1 replace for Dish-Network Remote Control TV DVD Satellite Receiver

Description: New DISH 20.1 replace for Dish-Network Remote Control TV DVD Satellite Receiver Use: TV Wireless Communication: IR Frequency: 433 MHz Model Number: For DISH 20.1 IR Applicable Model: For DISH 20.1 IR Attributes: TV/o/Video Remote Control Controle Remoto Controller Fernsteuerung colour:Black silver material:ABS size:10x6x3cm Package Contents: 1 * Remote control Only the above package content, other products are not included. Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm. Compatible with TV models :VIP 622, 722, 222, 522, 625, 942, 201, 211, 301, 311, 322, 351, 1000, 2200, 2700, 2800, 2900, 3000, 3200, 3700, 3800, 3900, 4000, 4100, 9200, 5200, 6000. 6100 it has no RF section. It can not be setup in SAT mode. If you have tried the remote control can't work, you can try to press TV device button long, the device lights up, enter the code 1005, and the device flashes two, then indicates that the setup is finished. Programming to Control Dish Receiver Although your remote may already be configured to work with your DISH receiver, there's a chance that you may need to program it. To test whether this is necessary, press the POWER button on the receiver to turn it on, and follow this up by turning on your HDTV or other television. Press the GUIDE button on your remote, and if the programming guide pops up, you can skip to "Programming 20.1 IR Remote for Other Devices." If the guide doesn't show up, press the SYSTEM INFO button that's located on your DISH receiver once. This will bring up the System Info screen. On your remote, press the SAT button, which should illuminate the SAT light. Press the RECORD button once. This will again cause the SAT button to light up. After releasing the RECORD button, press the SELECT button, located on the front of your receiver, to exit out of the System Info screen. Once this is done, point the remote at the television where it will be used. Press the GUIDE button on your 20.1 IR remote once, and this should bring up the programming guide to show everything has gone smoothly. Programming 20.1 IR Remote for Other Devices Once you're sure your DISH receiver and 20.1 IR remote are connected properly, programming the remote to your DVD player or other device is a cinch. While facing the device that you need to program, press the button that corresponds to the device you're programming (TV, DVD, AUX, etc). Hold the button down until all four mode buttons light up. You will now need to enter the three-digit manufacturer code that correlates with the device you're programming. Unfortunately, these codes can vary immensely. A code for a home stereo system and television from the same manufacturer, for instance, will not be the same. Luckily, DISH has remote control codes readily available and easily searchable on their website. After entering the three-digit code, the mode button you're programming will light up. Press the POUND (#) button once. This should cause the specific mode button to blink three times. Your device should now be configured. Test this by pressing the VOLUME, PLAY, or other buttons related to the device.

Price: 10.26 USD

Location: Guangzhou

End Time: 2023-11-17T11:15:24.000Z

Shipping Cost: 0 USD