Mark Levinson N. 20.5 Monaural Power Amplifier 2x 100 Watts RMS Hi End Good Look

Description: Mark Levinson N.20.5 Monaural Power Amplifier 2X 100 Watts RMS Hi End Good LookThe description of this item has been automatically translated. If you have any questions, please feel free to contact us. MARK LEVINSON b. 20.5 MONAURAL Power Amplifier 2X 100 Watts RMS Hi End Good LOOK WORK PERFECT, NO PROBLEM, VERY LOW USE MARK LEVINSON b. 20.5 Dual MONAURAL MONOBLOCK Power Amplifier 100 Watts RMS / 8 ohms 200 Watts RMS / 4 ohms 400 Watts RMS / 2 ohms Hi End Good Look Monaural Power Amplifier (1989) Sidebar 2: No.20.5 Measurements According to the specifications in the heading, the No.20.5 appears to be a "perfect" amplifier in that its output power almost exactly doubles when the load impedance is halved from 8 to 4 ohms, and again when it drops from 4 to 2 ohms . On the test bench, the measured continuous maximum output power into 8 ohms (actually 8.1 ohms) for a 1% distortion figure was 139.3W (21.4dBW footnote 1). Into 4 ohms, it raised 258.5W (21.1dBW), and into 2 ohms, 410.5W (20.1dBW), which is not far removed from the specification. (That these figures are a little higher than implied by the specification may be due to the wave-shaping taking place as the amplifier approaches clipping, which might allow slightly higher power to be reached for a nominal 1% THD figure.) Certainly this is one powerful amplifier, with its almost perfect "voltage source" nature indicated by the very small drop in the dBW figure each time the load impedance halves. Distortion levels were also low, THD and noise measuring around 0.005% across the band at a 1W output level with Stereophile's new Audio Precision test setup. The voltage gain was almost exactly to spec at 25.9dB, 100mV in giving 1.944V out. For those who are wondering if the subjective bass strength noted was a function of a high output impedance, this was very low across the band compared with the Prodigy and other tube amplifiers, ranging from 0.012 ohms at 20Hz to 0.015 ohms at 1kHz and 0.05 ohms. at 20kHz (measured at an output level of 50mW). The measured frequency response also gave no clues to the amplifier's tonal balance, this being ostensibly flat in the audio band, with a lower limit of -1dB at 7Hz and -3dB at 3.5Hz. Interestingly, though the No.20.5 subjectively had a heavier bass than the Prodigy OTL design, the latter actually had greater LF extension (both, of course, were ostensibly flat to 20Hz). This can be seen on the slope of the top of the waveform shown in fig.1, which shows a 20Hz squarewave measured at the terminals of the Celestion SL700 loudspeakers when driven by the Levinson. Compare that with fig.2, which shows the waveform when the speaker was driven by the Prodigy. (Both were measured at a 100mV input level.) I can only assume that the quality of the 20.5's subjective bass response has more to do with the incredible stiffness of its power supply. Input sensitivity: 0.141V Dimensions: 212.3 x 444.5 x 560.2mm Weight: 2 X 40.9kg Year: 1989According to the specifications in the heading, the No.20.5 appears to be a "perfect" amplifier in that its output power almost exactly doubles when the load impedance is halved from 8 to 4 ohms, and again when it drops from 4 to 2 ohms . On the test bench, the measured continuous maximum output power into 8 ohms (actually 8.1 ohms) for a 1% distortion figure was 139.3W (21.4dBW footnote 1). Into 4 ohms, it raised 258.5W (21.1dBW), and into 2 ohms, 410.5W (20.1dBW), which is not far removed from the specification. (That these figures are a little higher than implied by the specification may be due to the wave-shaping taking place as the amplifier approaches clipping, which might allow slightly higher power to be reached for a nominal 1% THD figure.) Certainly this is one powerful amplifier Número de entradas 2 Número de canales 1 Garantía del fabricante Sin garantía Tipo Etapa de potencia EAN No aplicable Color Negro Marca Mark Levinson Entradas de audio Estéreo RCA Entradas de audio XLR Año de fabricación 1989 País/Región de fabricación Estados Unidos Cantidad de unidades 2 Tipo de unidad Unidad Salidas de audio Banana Jack Modelo N. 20.5 Número de salidas 1 Características 2 Monoblock Monaural Potencia 100 W

Price: 12280.74 USD

Location: Albarizas

End Time: 2024-09-30T14:32:35.000Z

Shipping Cost: 379.18 USD