Lot of 5 ~ FIBER Cable Dulmison Aluminum Support Clamp & ADSS FOSC6060-PB insert

Description: This listing is for one (1) lot of five (5) clamps. Fiber optic ADSS Cable ClampSuspension & Support ~ cable diameter .576-.625 in New old stock ~ never field installed on utility poles or structures The Fiber Optic Support Clamp system is designed to gently but firmly support ADSS cable. It is intended for tangent support installations on lines that feature relatively low voltages, short spans, and modest mechanical loads. Mounts to a pole with a 5/8" through bolt or with a 1-1/4" wide x 0.040" thick (32 mm x 1 mm) steel bandSupports span lengths up to 600 ft (183 m) NESC Heavy for cables with diameters less than 1.0" and 300 ft (91 m) NESC Heavy for cables with diameters greater than 1.0"Supports line angles up to 20 degrees • Base and keeper are made from aluminum alloyInserts are made from a soft, pliable dielectric material that gently grips and cushions the cable within the housingHinged keeper is secured to the base with a captured galvanized steel bolt, lock washer, and washerMultiple assemblies can be stacked together for multi-cable installationsCable cavity is contoured and smooth to allow it to be used as a stringing traveler at the structure Note: purchaser to confirm inserts are for ADSS fiber optic cable diameter of cable supplied by others; see above for cable diameter Note: some o-rings temporarily holding clamp bolts in place may require replacement by buyer, if applicable (apply cable tie temporarily to bolt or apply tape, or replace o-ring) depending on your method of use during cable install; one time open and close to place cable, or removing insert to use as traveler and then reinstall insert.

Price: 194.95 USD

Location: Commack, New York

End Time: 2024-10-29T11:57:41.000Z

Shipping Cost: 9.99 USD