Description: Technical Product Bulletin1.5G Thermal Compound Grease CPU Heat Sink Conductive Paste *USA Seller Fastship PRODUCT DESCRIPTION: Heat sink thermally conductive grease compound, used successfully by Ford Motor Company for 20 years, direct replacement for Dow 340 and Wakefield 120,complies to MIL-DTL-4-7113, less than 30µ particle size, low bleeding, low VOC.This product is an opaque white heat sink grease compound, which is applied to the base and mounting studs of transistor and diodes to provide a positive heat sink seal, this facilitates heat transfer away from electrical/electronic components andinto heat sinks, thereby increasing the overall efficiency and performance of the device. It is grease like silicone material, heavily filled with efficient heat conductive zinc oxide and a binding agent, this combination promotes high thermal conductivity, high temperature stability, and the lowest amount of bleed and evaporation. This thermal compound resists changes in consistency temperatures up to 180°C; function as heat transfer media, durable dielectric insulation, barrier against environmental contaminants and as a stress-relieving shock and vibration absorber over a wide temperature and humidity range.This thermal paste is resistant to ozone and ultraviolet degradation and has good chemical and solvent stability, goodinterference between the heat producing device and the heat transfer media, and low surface tension that enables them to wet most surfaces. It will not harden, dry, or melt after 1200 hours @ 205°C. Used by Ford Motors for over 10 years. ELECTRICAL PROPERTIES:Dielectric Strength, volts/mil (ASTM D 150)390Dielectric Constant @ 100Hz (ASTM D150)4.40Dissipation Factor @ 100Hz (ASTM D150)0.0021Volume Resistivity, ohm-cm (ASTM D257)2.9x1014 THERMAL PROPERTIES:Thermal Conductivity W/m-K0.88Operating Temperature Range, °C-60 to 205Thermal Resistance °C-In2 /W0.05 TYPICAL PROPERTIES AND CHEMICAL CHARACTERISTICS:ColorWhiteBase FluidDimethyl PolysiloxaneFillerZinc oxideSpecific Gravity, 25°C, gm/cc2.45ViscosityPastePress Flow @ 42.5 PSI, 25°C sec13Penetration (Worked), mm2851/10Evaporation 24 hrs @25°C, %0.0Evaporation @ 200°C 24H by weight,%0.5Bleed 24 Hours, %0.6 POTENTIAL USES:· Effective thermal coupler for any heat sink device, CPU to heat sink· Automotive temperature-sensing devices· Temperature sensors· Applied to the base and mounting studs of transistor, diodes and silicone controlled rectifiers· Power transistors· Diodes, semiconductors· Thermal Joints· For any device where efficient cooling is required· Potting· TEC Modules· Hardware· Telecommunications· Right product for thermal management· High-voltage corona suppressant in connectors for fly back transferors located in TV sets. · Non-Sag or flowing· Non-Hazardous polymerization· Non-Toxic· Non-Corrosive· Reworkable· Easily removed· Non-Flammable· Easy to apply via dispensing or screen printing· Low surface tension that enables it to wet most surfaces, which can lower the thermal contact resistance between the substrate and material. APPLICATION METHODS:Automated or manual dispensing USAGE INSTRUCTIONS:For industrial use only Read MSDS carefully prior to use. LIMITATIONS:This compound is neither tested nor represented as suitable for medical or pharmaceutical use. STORAGE HANDLING & SHELF LIFE:This product has a shelf life of 5 years at room temperature (76°F) in an unopened container, settlings may occur during long term storage, it isrecommended to re-mix the filler by hand or mechanical mixing. Keep container tightly closed store in cool area away from ignition sources and oxidizers,no special precautions need to be taken if product is handled according to directions. Shelf life is indicated on the product label, any special storage andhandling instructions will be printed on the product container label. CLEAN UP & DISPOSAL:This product can be removed by using solvents such as mineral spirit, heptane, or isopropyl alcohol. Dispose of in accordance with local, state and federal regulations for hazardous waste. SHIPMENT & PACKAGING:U.S made quality product - We ship internationally. Multiple use syringe with cap. This formulation is comparable to or better than Arctic Silver. PRICES:1.5gm syringe(s) ($2.99)3gm syringe(s) ($3.99)5gm syringe(s) ($4.99)10gm syringe(s) ($7.99)100gm jar(s) ($29.99)250gm jar(s) ($45.99)500gm jar(s) ($70.99) Froo www.froo.com | Froo Cross Sell, Free Cross Sell, Cross promote, eBay Marketing, eBay listing Apps, eBay Apps, eBay Application
Price: 9.99 USD
Location: Warwick, Rhode Island
End Time: 2024-02-21T19:42:15.000Z
Shipping Cost: 0 USD
Product Images
Item Specifics
Restocking Fee: No
Return shipping will be paid by: Buyer
All returns accepted: Returns Accepted
Item must be returned within: 14 Days
Refund will be given as: Money Back
Type: Thermal Compound
Packaging: Syringe
Brand: Atom Adhesives
MPN: AA-Grease 04-1
Country/Region of Manufacture: United States
Typical Applications 1:: Effective thermal coupler for any heat sink device
Typical Applications 2:: CPU to heat sink Temperature sensors.Potting
Typical Application 3:: Automotive temperature-sensing devices.
Typical Applications 4:: base and mounting studs of transistor, diodes
Typical Applications 5:: silicone controlled rectifiers Power transistors
Typical Applications 6:: semiconductors Thermal Joints TEC Modules
Typical Applications 7:: Hardware Telecommunications Right product Thermal
Thermal Applications 8:: High-voltage corona suppressant Transferors
