Car Body Paintless Dent Repair Tools Slide Hammer Puller Lifter Hail Removal Kit

Description: Name: Automotive Depression Repair Tool Material: Iron+Plastic Features: 1.2 Integrated T-shaped rod puller (long and short) 2. The operation is simple and very easy to control, and everyone can easily remove dents on their own 3. Will not damage the surface of the car 4. Metal structure, sturdy and durable 5.2 updates, lighter body 6.18 labels of different sizes, suitable for large or small dents 7. High viscosity adhesive strip for faster repair of dents Frequently asked questions: 1. Insufficient glue heating Fully heat for 5-7 minutes until there is liquid at the muzzle or gently press the switch to release the glue 2. The adhesive on the gasket is too little or too thin It needs to be uniform and thick. You can apply a little more in the middle and quickly stick to the concave area after coating 3. Wrong traction direction When pulling, it should be as perpendicular to the body as possible 4. Excessive tension It should be evenly and moderately repeated multiple times 5. Excessive force cannot stick to the suction cup Excessive force can easily squeeze the glue out, so you should gently press for 2-3 seconds 6. Pulling time issue After connecting the suction cup, wait for the glue to cool and there is residual temperature before pulling it out. The temperature of the sol is too high, or it has completely cooled before pulling, making it easy to fall off 7. The suction cup is easy to fall off because there is dust or water floating on the surface The depression should be cleaned with water and wiped dry with a towel 8. The body temperature is too high in summer Cool the depressed area with cold water first, then wipe dry the water 9. Low body temperature in winter First heat the concave area with hot water, then wipe the water dry 10. Suction cup size issue The larger the suction cup, the greater the suction force, suitable for flat and concave areas Important information: Due to the different heating time and application thickness of the adhesive tape, it may fall off in one operation. Therefore, it is necessary to be patient and repeat the operation multiple times! You can also use other things to test if the glue is sticky! Is the residual glue not clean? 1. When spraying, use high concentration alcohol to clean with a spatula (diesel, gasoline, and asphalt can also be tried) 2. Heat the adhesive with a hot air fan and clean it with a spatula 3. When pouring in, use hot water above 80 degrees Celsius to clean it with a spatula How to use a dent puller kit to repair dents on a car? Before first use, soak the label in 91% rubbing alcohol and dry it. 2. Insert the glue stick into the glue gun. Insert the glue gun and let it heat for 5 minutes. 3. Clean the area to be repaired with 91% isopropanol and a clean towel. 4. By comparing it with the size of the dent, select the correctly sized dent tab. 5. When performing multiple repairs, in order to save time, please glue and place all the tabs on the vehicle at once, and then perform all repairs. 6. Pull the trigger of the glue gun and apply hot glue to the dented tab until approximately a dime of glue is released. For smaller labels, use "pea" sized glue droplets, and for larger labels, use a dime sized or slightly larger glue droplet. 7. Apply the dent tab to the exact center of the dent. 8. Allow the glue to set for approximately 5 minutes. When you start repairing, the glue should feel very hard. 9. Slide the dent elevator device directly onto the dent tab shaft

Price: 18.9 USD

Location: Humble, Texas

End Time: 2024-08-22T08:48:25.000Z

Shipping Cost: 0 USD