Description: Blue Bird bus has a problem with the cup holders letting your drink drop through if you hit a bump right or if the bottom holder that swings out breaks off. This cup holder will fit in the OEM cup holder with or without the arm. Note: when you install it, hold the factory cup holder with one hand and with the other hand carefully spin and lightly push the new one down until it locks into place and is flush on the top and bottom. inside size 82 mm +/-1mm UPDATE: see new insert that goes in this for smaller drinks. this is the insert only and not the OEM cup holder. you still need to have the OEM cup holder in the bus. CLIMATE NOTE: This is printed in PLA plastic which is known to warp in higher temperatures or become brittle when exposed to UV light. If your car is in a hot climate and in the sun, the high temperatures (>125℉) and direct sunlight could warp this adapter or cause it to break. This particularly applies to places like Phoenix, Southern California, etc. where temperatures regularly reach into the 100℉. An average "hot" summer day in Minnesota, or Wisconsin, or New York could also warp these if your car sits in the sun! This product is 3D printed. Due to the nature of 3D printing, there may be a seam, layer lines, and/or small imperfections. Washing instructions: Hand wash only with cool, soapy water. Rinse and dry.
Price: 12 USD
Location: Lakeville, Minnesota
End Time: 2024-08-20T20:18:25.000Z
Shipping Cost: N/A USD
Product Images
Item Specifics
All returns accepted: ReturnsNotAccepted
Type: Photograph
Available Variations
Color: black
Price: 12 USD
Available Quantity: 3
Quantity Sold: 1
