Description: 3D Printed 2001-2007 1st Gen Toyota Sequoia/Tundra Scangauge II Mount is a direct replacement for the stock ashtray. This is used for mounting your Scangauge II using double sided tape and gives a clean OEM look that allows you to also route the wiring through the dash. THIS IS FOR A MOUNT ONLY!! Scangauge II NOT INCLUDED!! To install first remove the stock ashtray by pulling it straight out. Then replace with this panel by sliding the longer flat piece through the slots on the sides. Please note as with all 3D printed items there may be some small imperfections/blemishes, however I do my best to provide the best looking and most durable prints that i can provide. Also keep in mind that 3D prints do have their limitations so please be careful when handling and during installation. These are unfinished/unpainted and are intended to be finished/painted by the end user. Printed in black ASA for better heat resistance and durability. This design is used with permission and was created by username 20vmki from Thingiverse and original STL file can be found here https://www.thingiverse.com/thing:5492331
Price: 34.99 USD
Location: Adelanto, California
End Time: 2025-01-14T14:59:09.000Z
Shipping Cost: 0 USD
Product Images
Item Specifics
Returns Accepted: ReturnsNotAccepted
Brand: Toyota
Type: Dashboard Trim
Color: Black
Material: Plastic
Finish: Matte
Placement on Vehicle: Center Console, Dashboard, Front
