2 09985 for Presto Pressure Canner Sealing Ring Gasket 01745 01751 01755 01781 0

Description: ✅ Compatibility: Our 09985 pressure canner sealing ring fits presto pressure cooker models 0174510(16 qt), 0175107(18 qt), 0175510(16 t), 0178107( 23 qt), 0178209( 23 qt ), 0178410( 23 qt ). It is the perfect presto 16 qt pressure canner parts, presto 23 qt pressure canner parts, and presto 18 qt pressure canner parts, bringing convenience to your cooking.✅ Function: The 09985 pressure canner sealing ring fits around the inside rim of the cover and forms a secure pressure-tight seal between the cover and the body of the pressure canner during canning and cooking. Replace the sealing ring every two to three years or when the canner is not able to build or maintain pressure. It should also be replaced immediately if the ring has shrunk, become hard, deformed, cracked, worn or pitted.✅ High quality: This 09985 pressure canner sealing ring is made of non-toxic and odorless high-quality food-grade silicone material. This silicone material is more flexible, heat-resistant, not easily deformed by heat, has excellent sealing performance and has a long service life. You can use it with confidence.✅ Installation: ① When installing the 09985 pressure canner sealing ring, install it into the cover in four small sections such as top, bottom, left and right. ② Put it into the groove a small portion at a time until it is fully seated. ③ Put the lid on the cooker body. ④ Place one hand on the top center of the lid and push down firmly. ⑤ Open and close the lid several times. Detailed installation and maintenance information is provided below.✅ Good after-sales Service: We have 24 hours online service and you can contact me anytime if you have any questions. For any reason you are not satisfied, you can request a free replacement. We always provide a 1 year replacement . Product Description 09985 Pressure Canner Sealing Ring presto 23 quart Pressure Canner Parts Very tight seal Two lines - strongly penetrates the ring on the IP cover Small gaps - the seal lasts and stays tight Excellent performance The sealing ring fits around the inside rim of the cover and forms a secure pressure-tight seal between the cover and the body of the pressure canner during canning and cooking. Installation Steps 1. Remove the old sealing ring and the overpressure plug. (The overpressure plug is under the handle on some models.) CAUTION: To insure safe operation and satisfactory performance from your pressure cooker, replace the automatic air vent every time you replace the sealing ring, or sooner if it becomes hard or inflexible. 2. Clean the sealing ring groove and the air vent opening thoroughly. Be sure they are free of all food particles and foreign material. 3. Wash the new sealing ring in warm soapy water, rinse and dry. Install the sealing ring by working it into the cover a small section at a time until it is fully in place. Any excess amount of sealing ring can be worked into the cover in this manner. 4. If necessary, to help make the cover easier to open and close, a very light coating of cooking oil may be applied to the underside of the body lugs and sealing ring. 5. To install the overpressure plug. Push the round side of the rubber plug (marked TOP) into the opening from the underside of the cover. 6. When putting the cover on the body, press one hand down on the area opposite the handle. This will help compress the sealing ring and make the cover easy to lock in place. Then, open and close the cover several times to make it operate more freely.

Price: 23.87 USD

Location: Denver, Colorado

End Time: 2025-01-17T15:08:17.000Z

Shipping Cost: 0 USD